User manual

7NetShelter SV User Manual
Cabinet Installation
Moving the Cabinet
Casters: To move the cabinet on its casters, the equipment load must be evenly distributed, must not
exceed 460 kg (1,014 lb) and the equipment must not be installed above the 20 U height.
Level the Cabinet
The front door may need to be reversed. See “Reverse the Front Door” on page 10 for removal and
installation instructions.
1. Using a 13 mm wrench, lower each
leveling foot until in makes contact with
the floor.
2. Adjust each foot until the equipment is
level and plumb.
WARNING
TIP HAZARD
This cabinet is easily tipped. Use extreme caution when unpacking or moving.
• Use at least two people to unpack and move the cabinet.
• Before moving the cabinet on its casters, load 158 kg (350 lb) of equipment into the
bottom equipment mounting space of the cabinet for extra stability.
• When moving on its casters, make sure the leveling feet are up and push the cabinet
from the front or rear.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
NOTICE
The leveling feet provide a stable base if the floor is uneven, but cannot compensate for a
steeply sloped surface.
ns2004a