Specifications

NetShelter SX Enclosure — Unpacking, Installation, and Customization Manual2
Unpacking the Enclosure
Disclaimer
APC by Schneider Electric is not responsible for damage sustained during reshipment of this product.
Receiving inspection
Inspect the package and contents for shipping damage, and make sure that all parts were sent. Report any
damage immediately to the shipping agent. Report missing contents, damage, or other problems
immediately to APC by Schneider Electric or your APC reseller.
Please Recycle
The shipping materials are recyclable. Save them for later use, or dispose of them
appropriately.
Unpacking Procedure
1. Move the shipping pallet to a firm, level surface.
2. Inspect for visible signs of shipping damage. If damage has been detected, contact APC
Customer Support using the contact information on the back cover of this manual.
3. Remove the plastic stretch wrap surrounding the equipment.
4. Remove the four cardboard corner protectors.
5. Using a 13-mm wrench remove the two pallet-mounting brackets. Save these mounting brackets
if you plan to bolt the enclosure to the floor.
6. Carefully roll the equipment off of the pallet and onto the floor.
WARNING
TIP HAZARD
This enclosure is easily tipped. Use extreme caution when packing or moving.
• Use at least two people to unpack and move the enclosure.
• Before moving the enclosure on its casters, load 158 kg (350 lbs) of equipment into
the bottom of the enclosure for extra stability.
• When moving on its casters, make sure the leveling feet are up and push the
enclosure from the front or rear.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.