Installation and Operation Manual APC Panel Mount Type 1 SPD PMP1XR-B
The APC PMP1XR-B Surge Protective Device (SPD) is designed to provide specification-grade performance at the service entrance, branch panels, or other critical locations. The APC SurgeArrest® PMP1XR-B comes with LED status monitoring in a Type 4X enclosure with 50 kA maximum surge current rating. Compliant with UL1449 3rd Edition requirements dated September 29, 2009.
Table of Contents Precautions ............................................................................................... 4 Introduction ............................................................................................... 5 Specifications and Installation ................................................................. 6 Customer Support ....................................................................................
Precautions Precautions DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH • Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E. • This equipment must only be installed and serviced by qualified electrical personnel. • Turn off all power supplying this equipment before working on or inside equipment. • Always use a properly rated voltage sensing device to confirm power is off.
Introduction Introduction Thank you for choosing the APC SurgeArrest® PMP1XR-B Surge Protective Device (SPD). The APC Surge Protective Device (SPD) is a high-quality, high-energy surge attenuation system that has been designed to protect sensitive equipment from damaging transient voltage surges. Proper installation is imperative to maximize the surge suppressor’s effectiveness and performance. This manual is to be used as a guide for installing the device.
Specifications and Installation Specifications Table 1: Voltage Rating Model PMP1XR-B Peak Surge Current (Rating per Phase) Voltage 120/240 V~ Table 2: L-N L-G 25 kA 25 kA Protection Side Nipple Surge + Overload General Specifications 1 System Voltage 120/240 V~ Maximum Continuous Operating Voltage (MCOV) Short Circuit Current Rating 2 Nominal Discharge Current (In) 150 V~ L-N, 300 V~ L-L 25 kA 10 kA (L1-N, L1-G, L2-N, L2-G) Voltage Protection Rating (VPR) 700 V (L1-N, L1-G, L2-N), 800
Specifications and Installation Figure 1: Mounting Nut Figure 2: Panel Wiring Black L1 White Black White L2 Black Single-phase 2-wire (+GND) 120 V~ Single-phase 3-wire (+GND) 120/240 V~ Diagnostic Operation LED OFF = Loss of Surge Suppression L1 and/or L2 LED ON = OK • • N Green Green Figure 3: L N LED ON = Normal Operation LED OFF = Check circuit breakers and connections. Verify line voltage at point of connection; if all correct, replace SPD.
APC Worldwide Customer Support Customer support for this or other APC products is available at no charge in the following ways: • Visit the APC website to access documents in the APC Knowledge Base and to submit customer support requests. — www.apc.com (Corporate Headquarters) Connect to localized APC Web sites for specific countries, each of which provides customer support information. — www.apc.com/support Global support searching APC Knowledge Base and using e-support.
