Operating instructions

2-4
2. Push the Battery Wire Connector (Figure 5) into the hole located at the left of the
Battery Pack. Ensure that the Battery Wire Connector is pushed into the hole and
securely connected by gently pulling on the wire to see if it is attached to the
connector.
Figure 5. Battery Wire Connection
3. Install the battery retaining bar.
4. Install the front Bezel (Figure 6), by aligning the four pins located on the back-side of
the Bezel to the holes at the left and right sides of the unit. Gently push the front Bezel
onto the unit.
Figure 6. Front Bezel Installation