Installation manual

Smart-UPS
®
VT SBP with Power Distribution 10-30kVA, 208V, Installation Manual - 990-4198A 1
Safety
SAVE THESE INSTRUCTIONS
This manual contains important instructions for the SUVT series that should be followed when
handling the Service Bypass Panel (SBP) with Power Distribution (wall-mount).
Safety warnings
Warning
WARNING!
Only APC-trained personnel who are familiar with the construction and operation
of this equipment, as well as the mechanical and electrical hazards involved, may
perform this installation.
WARNING!
This installation must comply with the requirements of ANSI/NFPA 75 and NEC/
NFPA 79 Art. 645.
WARNING!
All safety codes, safety standards, and other regulations must be strictly observed
during installation and ongoing maintenance of this equipment.
Electrical
Hazard
WARNING!
Prior to installing the Smart-UPS VT SBP with Power Distribution, de-energize all
external power being supplied to the UPS!
WARNING!
Ensure that no electrical power is connected to the SBP, and that all switches are in
the OFF position before installing or servicing this unit!
WARNING!
All wiring instructions must be followed precisely. Failure to comply could result in
permanent damage to the equipment!
WARNING!
When installing this unit to a wall, avoid contact with previously installed electrical
wires and other potential hazards that might be embedded in the wall!