Installation guide

28 Installation Guide Silcon DP300E 480V 120-160kVA

7OH0006 US rev. 03

Connection

Installing accessories – procedure:

To install accessories, perform the following steps.

1. Make sure that the Silcon DP300E is powered off.

2. Install the SmartSlot accessories into the housings on the front of the chassis.

See the instructions supplied with the accessories and “Priority of APC accesso-

ries.”

If your UPS has one SmartSlot accessory slot

If your UPS has exactly one SmartSlot accessory slot, use this accessory slot for the

SmartSlot device with the lowest priority.

Installation in the Silcon DP3120E and DP3160E

For installation of multiple SmartSlot devices in the Silcon DP3120E and DP3160E,

refer to the numbering shown in the figure that follows:

SmartSlot