Specifications

990-1986C-001
9/2009
*990-1986C-
Installation
Smart-UPS
®
VT
10-40 kVA 380/400/415 V with batteries

10-40 kVA

20-40 kVA without front panel

10-15 kVA without front panel

10-40 kVA from the rear

10-20 kVA

10-20 kVA without front panel

10-20 kVA from the rear
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Warning: ALL safety instructions in the Safety Sheet
(990-2822) must be read, understood, and followed when
installing the UPS system. Failure to do so could result in
equipment damage, serious injury, or death.
Warning: After the UPS has been electrically wired, do
not start it up. Start-up is commissioned to authorized
personnel from Schneider Electric Critical Power &
Cooling Services only.
Caution: All electrical power and power control wiring
must be installed by a qualified electrician, and must comply
with local and national regulations for maximum power
rating.
Note: Ensure that the unit is in its final location prior to
installation.
Note: Battery and utility/mains power must not be
connected until all other wiring has been completed.
Level the Enclosure
Warning: The system must be installed on a level floor.
The leveling feet will stabilize the enclosure, but will not
account for a badly sloped floor.

Use a 13/14 mm wrench to adjust the four leveling feet.

Ensure that the system is level.
Caution: Do not move the enclosure after the leveling feet
have been lowered.
Floor Anchoring (if applicable)
Anchor the UPS enclosure to the floor
Note: Floor-anchoring bolts are not provided with the UPS.
Purchase the bolts locally (minimum size: M8). Follow the
specifications given by the manufacturer of the floor
anchoring system when bolting the UPS system to the floor.

Reuse the two transport brackets (one
on each side) that were used to secure the
UPS to the pallet during transport.

Drill two to six holes in the floor for
each bracket. Attach with bolts.











