User Manual

Smart-UPS C 1000/1500 VA 120/230 Vac Tower / Rack-Mount 2U 11
Display Menu
The main part of the display will show different parameters of the UPS. Pressing the menu button will toggle
through the various menus programmed for Output Voltage, Runtime, Input Voltage, SmartConnect Status, etc.
Feature Reference Guide
Normal mode
Configuration mode
Configuration mode provides the ability to adjust UPS parameters and initiate control actions. To enter
configuration mode hold the M
UTE and MENU buttons together for 2 seconds until the system emits a
short beep and the display will flash to indicate the UPS has entered Configuration Mode.
When in Configuration Mode, the MENU button cycles the display through the available options. The M
UTE
button toggles the configuration settings for that option.
Note: When the UPS detects 20 seconds of no activity in Configuration Mode, or when the M
UTE and MENU
buttons are pressed together for 2 seconds until the system emits a short beep, the UPS returns to Normal mode.
System Error Detected
The UPS has experienced
an internal error.
120 Vac models
230 Vac models
N/A Identify the error message on the
display and refer to the table of
codes under “System Errors and
Message Codes” section on
page 15.
Function Button
Timing
(seconds)
UPS
State Description
Power
Power On
0.2 Off
Press the POWER ON/OFF button to turn the UPS output on. The
UPS will operate on AC power.
If AC power is not available the UPS will operate on battery power.
Power Off
5 On
Press the POWER ON/OFF button to turn the output off using
shutdown delays. To turn the output off immediately press and hold
the POWER ON/OFF button for 5 seconds.
Display
Menu Button
0.2 On
The Menu button will advance the display to the next data item. If
the display is darkened to save energy, pressing the Menu button
will illuminate the display.
Mute
Enable/Disable
2 On
Enable or disable the audible alarms. The Mute icon will illuminate
and the UPS will beep once.
Error Reset
2 Error
After an error has been identified, press the
POWER ON/OFF button
to remove the visual indication and return to standby status.
Status LCD Icon Audible Alarms Audible Alarm Terminates