Datasheet

5Smart-UPS C 1000/1500 VA 120/230 Vac Tower
Configuration mode
Configuration mode provides additional UPS configuration options. Press and hold the MUTE and MENU buttons
for two seconds. The UPS will emit a short beep and the two icons will flash to indicate that
Configuration mode is enabled.
When Configuration mode is enabled use the
MENU button to scroll through the available options. Use the MUTE
button to scroll through the settings in each option.
Note: The UPS will automatically disable Configuration mode after 15 seconds of no activity. To
manually disable Configuration mode, press and hold the
MUTE and MENU buttons for two seconds.
The UPS will a emit a short beep.
Function Options Description
Self-Test
• 0: Default Setting
• 1: Begin Self-Test
0 is the default setting for Configuration mode. Press the MENU button to scroll
through the available options.
Press 1 to manually initiate a Self-Test. The UPS will automatically disable
Configuration mode.
Note: When the UPS is operating on battery power and Configuration mode is
enabled, only the default setting will be available. A manual Self-Test cannot
be initiated.
Power Quality
• Good
•Fair
• Poor
Select the input utility power quality tolerance.
• When Good is selected, the unit will go on battery power more often to
provide the cleanest power supply to the connected equipment.
• When Fair is selected, the UPS is under normal operating conditions.
• When Poor is selected, the UPS will tolerate more fluctuations in power and
will go on battery power less often.
If unsure of the local power quality, select Good.
Output Voltage
Setting
230V models only
• 220 Vac
• 230 Vac
• 240 Vac
Select the appropriate voltage for outlets when the UPS is in battery mode.
LCD Display
Dimmer
• Load Bar Icon shows
100% = Always On.
• Load Bar Icon shows 0%
= Auto Dim.
When the LCD display dimmer is configured to Auto Dim the LCD will
illuminate if a button is pressed or an event occurs. The display will
automatically dim after 60 seconds of no activity.
Green Mode
Enable
•0: Disable
• 1: Enable
When Green Mode is enabled the UPS is operating at the most efficient level,
bypassing unused AVR components while acceptable utility voltage is present.
The UPS will enter and exit Green mode automatically while enabled.
Clear Event
Counter
N/A
Press the
MUTE button to clear the event counter.