User's Manual

Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower / Rack-Mount 2U 21
UPS IP Address settings
SmartConnect
APC SmartConnect allows you to monitor the health and status of your UPS from any device connected to the
Internet. Visit www.smartconnect.apc.com to learn more.
Setting Factory Default Options Description
UPS IP Address
Mode
DHCP • DHCP
• Manual
Selects the IP address configuration mode of UPS
embedded SmartConnect port:
• DHCP: UPS will automatically configure its IPv4 address
via DHCP protocol.
• Manual: Manually assigns a static IPv4 address to UPS
IP Address 000.000.000.000 A valid IPv4 address This is the IPv4 address assigned to the embedded
SmartConnect port.
When DHCP IP address mode is selected, it will display the
UPS IPv4 address assigned by DHCP server.
When Manual IP address mode is selected, you need to
manually specify a static IPv4 address.
Subnet Mask 000.000.000.000 A valid IPv4 subnet
mask
Assigns the subnet mask of the network where UPS IPv4
address belongs.
When DHCP IP address mode is selected, it will display the
subnet mask assigned by DHCP server.
When Manual IP address mode is selected, you need to
manually specify the subnet mask of the network where the
specified static IPv4 address belongs.
Default Gateway 000.000.000.000 A valid IPv4 address This is the IPv4 address of the host from where the UPS
sends data to another network or Internet.
When DHCP IP address mode is selected, it will display the
default gateway assigned by DHCP server.
When Manual IP address mode is selected, you need to
manually specify the IPv4 address of default gateway.
DNS Server 1 000.000.000.000 A valid IPv4 address The IPv4 address of first domain name server (DNS) the
UPS uses to resolve host names to IPv4 addresses.
When DHCP IP address mode is selected, it will display the
IPv4 address of the first DNS server assigned by DHCP
server.
When Manual IP address mode is selected, you need to
manually specify the IPv4 address of the first DNS server.
DNS Server 2 000.000.000.000 A valid IPv4 address The IPv4 address of second domain name server (DNS) the
UPS uses to resolve host names to IPv4 addresses (only
when UPS fails to resolve IP address through first domain
name server). This setting is optional.
When DHCP IP address mode is selected, it will display the
IPv4 address of the second DNS server assigned by DHCP
server.
When Manual IP address mode is selected, you can
manually specify the IPv4 address of the second DNS
server or leave it as 000.000.000.000.