Installation guide

Installation Guide Smart-UPS X Tower/Rack-Mount 2U 100-240 Vac 2000/2200/3000 VA 7
Electrical connections
1. Connect equipment to the outlets on the rear panel of the UPS.
2. Connect the UPS to the building utility power.
3. To use the UPS as a master
ON/OFF switch, turn on all the equipment that is connected to the UPS.
4. Press the
ON/OFF button on the front panel of the UPS to turn on the UPS and all connected equipment.
5. Refer to the Switched Outlet Groups section in the Operation manual for information on how to
use the switched outlet groups.
Display Interface
CAUTION
RISK OF EQUIPMENT DAMAGE
• Adhere to all local and national electrical codes.
• Wiring should be performed by qualified electrician.
• Always connect the UPS to a grounded outlet.
Failure to follow these instructions can result in equipment damage
1
Online LED
2
UPS Output On/Off
3
On Battery LED
4
Site Wiring Fault LED
5
Replace Battery LED
6
Display screen
7
UP/DOWN arrow keys
8
ENTER key
9
ESC key
su0475a
su0343a
APC b
y
Schneider
Electric