Datasheet

16
1. Face the front of the battery pack and, using both hands,
insert each index finger behind the lip of the curved
section of the front bezel and pull towards you. The front
bezel will unsnap.
2. Set the bezel aside. The two battery compartments  will
be visible.
3. Use a screwdriver or coin to remove the two (2) screws 
and open the door. The door is hinged in the center of the
chassis.
4. Take out the white cord, which is tucked into the space
above the battery tray handle. Grasp the cord and pull
firmly towards you to disconnect the battery.
5. Use the battery tray handle  to slide the tray out most of
the way (when all four batteries are visible). Then support
the tray from the sides and lift the back of the tray over the
stops .
6. Return the battery tray to APC. (Refer to How To Contact
APC, page 4, for information.) The battery replacement
kit includes two new battery trays.
7. Hold the new tray on the sides, align it with the opening,
and lift it slightly to clear the stops. Then level the battery
tray and slide it into the unit.
8. Remove the tape on the new battery tray connector to
expose the cable connector.
9. Locate the battery connector which is to the side of the
battery tray and recessed. Connect the battery cable
connector to the connector. Press firmly to ensure that the
connection is tight. You will hear a “snap” when the
connector is properly seated.
10. Tuck the white battery cable cord neatly into the space
above the battery tray handle.
11. Close the door and replace the two (2) screws removed in
step 3.
12. Repeat steps 3 through 11 to replace the second battery
tray.
13. Align the tabs the front panel bezel with the slots on the
front of the battery pack and firmly snap it into place.








