User`s manual

1. Once the feet have been removed, snap apart each

foot into two end brackets.

2. Each foot needs one expansion piece  for each

external battery pack you are using. Additional

expansion pieces are shipped with the external

battery packs. Snap all center expansion pieces

together, and then snap the brackets  back onto

the ends of the expansion piece(s) to complete the

foot. Repeat with the other foot.

EMOVING THE BATTERY TRAYS FROM THE BATTERY PACK

The battery pack is heavy

. To lighten it, remove the battery trays. Battery trays in your external

battery pack are installed and removed just like the battery tray found in your UPS.

The battery trays are accessible from the front of the

battery pack (shown at left). This procedure requires

a Phillips screwdriver.

1. Notice that two battery tray compartments  are

visible. The External Battery Pack is shipped

with the bezel  removed, but the top decorative

panel  attached.

2. If your external battery pack has been in opera-

tion, you will need to remove the top decorative

panel and front bezel before gaining access to the

battery compartments. Remove them using

instructions found in your UPS User’s Manual.

3. Continue following instructions in the UPS

User’s Manual section Remove and Reinstall

Battery Pack to remove the battery doors, discon-

nect batteries (if the battery pack has been in use;

the batteries are shipped disconnected) and re-

move the battery trays.

OSITIONING THE BATTERY PACK AND UPS

If more than 2 external battery packs are to be connected to the UPS, you will need

more than one person to properly support and rotate the attached units during the instal-

lation, even after removal of all battery trays.







