Instructions / Assembly

1
Riser
Tube
Fo
r Flexible Line
Faucet
Shank
Main Water
Supply
Shut-off
Valve
Riser
Tube
For Solid Line
Faucet
Shank
Needle
Valve
Needle
Valve
Main Water
Supply
Shut-off
Valve
Sink
Sink
Needle Valve:
To open needle valve: Turn needle handle counter-clockwise.
To close needle valve: Turn needle handle clockwise.
Test for leaks at this point: Close the Needle Valve. (turn needle handle clockwise all the way in to close) Turn ON the
cold water supply to the sink faucet. If the Needle Valve or the Adaptor leaks, check the connection and try applying more
Teflon tape or tighten the brass nut some more to stop the leak.
Needle Valve Installation (See Fig. 1A): Attach the needle valve (C) to water supply adapter (A). Please apply
5-6 wraps of teflon tape to needle valve prior to connecting it to the water supply adapter (A).
If your pipe has a 1/2” Connection (See Fig. 1B): By attaching the 1/2” x 3/8” converter (B) to the Male
end of the water supply adapter (A), you now have a 1/2” Male and Female water supply adapter.
If your pipe has a 3/8” Connection (See Fig. 1C): By attaching the 1/2” x 3/8” converter (B) to the Female
end of the water supply adapter (A), you now have a 3/8” Male and Female water supply adapter.
Fig. 1A
Fig. 1B
Fig. 1C
1/2” Connection
3/8” Connection
Recommend Connection For Flex Line Riser (See Fig. 2A): Loosen nut and separate cold water riser
tube from faucet shank. Gently bend riser tube so that the Feed Water Adapter fits onto the faucet shank. Connect
the riser tube, the feed water adapter, and faucet shank together and tighten.
For Solid Copper Riser (See Fig. 2B): Follow the same procedure as for flex line. If the copper riser can-
not bend, then it’s best to replace it with a flex line riser. Then fit the feed water adaptor the same way as described
above.
Fig. 2A Fig. 2B
Fig. 2C
Movekit Installation Instruction