Installation Guide

10
MOUNT DRAIN
SADDLE AT
EITHER
LOCATION
Step 2: Drain Saddle Installation
Note: To avoid annoying drainage noise, mount drain line as low as possible
on the vertical tailpiece, or on horizontal tailpiece.
There is constant water pressure “packed” inside the RO system which blocks the waste water
from backing-up into the system. So the waste water is “forced-drained”, not “gravity-drained”.
1. See Fig. 7. The drain saddle assembly should be installed above the trap and on the vertical
or horizontal tailpiece . To reduce the drainage noise, mount the drain line as low as possible
above the trap, or on the horizontal tailpiece.
2. Select the location of the hole and drill a 1/4’’ hole through one side of the drain pipe then
put the self-adhesive black sponge around the hole location (See Fig. 8A and 8B).
Next, align and install the drain saddle clip with the tubing connection port onto the black
sponge. This will cushion any gap between the saddle and the pipe. Make sure the hole on
the sponge is thoroughly punched out, and is aligned to the hole on the saddle to complete
the installation (See Fig. 9)
Fig. 7
Fig. 8A Fig. 9Fig. 8B
1
0
M
O
UNT DRAIN
S
ADDLE
AT
E
ITHE
R
L
O
CA
TION
A
A
Step 2: Drain Saddle Installatio
n
N
ote
:
To avoid annoying drainage noise, mount drain line as low as possible
yg g , p
on the vertical tailpiece, or on horizontal tailpiece.
p , p
There is constant water pressure “packed” inside the RO system which blocks the waste wate
r
f
rom backing-up into the system. So the waste water is “
f
orced-drained”, not “gravity-drained”
.
1
. See Fig. 7. The drain saddle assembly should be installed above the trap and on the vertical
o
r horizontal tailpiece . To reduce the drainage noise, mount the drain line as low as possible
above the trap, or on the horizontal tai
lp
iece.
2
. Select the location o
f
the hole and drill a 1/4’’ hole through one side o
f
the drain pipe then
put the sel
f
-adhesive black sponge around the hole location (See
Fig. 8A
and
A
8B
)
.
N
ext, align and install the drain saddle clip with the tubing connection port onto the black
s
ponge. This will cushion any gap between the saddle and the pipe. Make sure the hole on
the sponge is thoroughly punched out, and is aligned to the hole on the saddle to complete
the installation (See F
i
g.
9
)
F
i
g. 7
Fig. 8
A
F
i
g.
9
F
i
g. 8
B