Installation Guide
1
Thank you for choosing APEC reverse osmosis systems.
You now own the finest water filter in America.
Please read and become familiar with instructions and parts needed before proceeding with the
installation.
BEFORE INSTALLATION:
Inspect the system:
Please take the system and all the components out of the box. Inspect the system and all the
connection fittings carefully, make sure nothing is damaged during shipping. If any part is cracked
or broken, please do not proceed with the installation and contact APEC or your distributor for an
exchange or diagnosis.
Recommended tools list:
x Variable speed drill
x Drill bit:
1/4” (for the waste line), 1/8” (as pilot, not mandatory), and 1/2” (for standard
faucet hole, air-gap faucet requires 1&1/4” hole)
x 5/8”, 9/16” open-end wrench, or adjustable wrench, pliers
x Phillips screwdriver
x Utility knife, or scissors
x Teflon tape
Operating Parameter
x Operating pressure: 85psi maximum
x Feed water temperature: 40 – 100 °F (4-37 °C)
x Feed water TDS level: 2000ppm maximum
x Do not connect this unit to hot water source
x Install the RO in a sheltered environment, avoid exposure to hot and cold weather or under
direct sunlight.
Copyright:
This manual is copyrighted by APEC Inc. Under the copyright laws, this manual may not be reproduced in any form, in
whole or part, without the prior written consent of APEC Inc. Manual print ver. 5.0, 2018 Sep.
General Installation/Operation/Maintenance Requirements
x Installation needs to comply with state and local laws and regulations.
x System must be installed indoor away from possible environmental damage
x Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after system. Systems certified for cyst reduction may be
used on disinfected water that may contain filterable cysts.
x This reverse osmosis system contains a replaceable treatment component critical for
effective reduction of total dissolved solids. The product water shall be tested periodically to
verify that system is performing satisfactorily.
1
Thank you
f
or choosing APEC reverse osmosis systems.
Y
ou now own the
f
inest water
f
ilter in America.
Please read and become
f
amiliar with instructions and parts needed be
f
ore proceeding with the
in
s
t
a
ll
a
ti
o
n.
B
EFORE I
N
STALLATIO
N
:
I
nspect the system:
P
lease take the system and all the components out o
f
the box. Inspect the system and all the
c
onnection
f
ittings care
f
ully, make sure nothing is damaged during shipping. I
f
any part is cracked
o
r broken, please do not proceed with the installation and contact APEC or your distributor
f
or an
e
xchange or diagnosis.
R
eco
mm
e
n
ded
t
oo
l
s
li
s
t:
x
V
ariable speed drill
V
V
x
D
rill
b
it
:
1/4”
(f
or the waste line), 1/8” (as pilot, not mandatory), and 1/
2”
(f
or standard
f
aucet hole, air-gap
f
aucet requires 1&1/4” hole
)
x
5/8”, 9/16” open-end wrench, or a
dj
ustable wrench,
pl
iers
x
P
hillips screwdrive
r
x
U
tility kni
f
e, or scissors
x
T
eflon tape
T
T
Op
erating Parameter
x
Operating pressure: 85psi maximum
x
F
e
ed water temperature: 40 – 100 °F (4-37 °C
)
x
F
e
ed water TDS level: 2000ppm maximum
x
D
o
n
ot
connect this unit to h
ot
water sourc
e
x
I
nstall the RO in a sheltered environment, avoid exposure to hot and cold weather or unde
r
d
irect sunlight.
Copyright
:
This manual is copyrighted by APEC Inc. Under the copyright laws, this manual may not be reproduced in any
f
orm, in
whole or part, without the prior written consent o
f
APEC Inc. Manual print ver. 5.0, 2018 Sep.
G
eneral Installation/O
pe
ration/Maintenance R
eq
uirement
s
x
I
nstallation needs to comply with state and local laws and regulations.
x
System must be installed indoor away
f
rom possible environmental damag
e
x
D
o not use with water that is microbiologically unsa
f
e or o
f
unknown quality without
ade
qu
ate disin
f
ection be
f
ore or a
f
ter s
ys
tem. S
ys
tems certi
f
ied
f
or c
ys
t reduction ma
y
be
used on disin
f
ected water that may contain
f
ilterable cysts.
x
This reverse osmosis system contains a replaceable treatment component critical
f
or
eff
ective reduction o
f
total dissolved solids. The product water shall be tested periodically to
veri
f
y that system is per
f
orming satis
f
actorily.