Installation Guide

17
Using RO for Ice-maker only:
If you want the RO to feed your ice-maker (fridge) only, you should still connect the RO faucet
as a 2nd outlet. This allows you to drain the tank, flush new filters through the faucet rather than
through your icemaker line. You can hang the faucet by the system and not mount it.
Option: Multiple Outputs - Add Shut Off Valve:
If your RO is feeding several output points (icemaker, fridge, bathroom), you should add a
Shut-Off valve to each output line (except the RO spigot line). This way, if you ever need to
diagnose a problem in the system, you can easily shut off these lines to isolate the water flow for
accurate troubleshooting.
Ball Valve
(Recommended)
Tee tting for
icemaker
Option: Ice-maker Connection
If you want to connect product water from the RO to your ice-maker, you will need:
x One T-fitting, preferably the quick-connect type fitting
x Extra ¼ “ tubing long enough to go from the RO system to your ice-maker
x Optional: One shut-off valve, preferably the quick-connect type.
See Fig.13. Before connecting the product water line from Point Z to H, add a T-fitting near
point H to divert product water to both the ice-maker and the faucet. It is best open the line to
the ice maker after the first tank has been discarded and the 2nd tank has completely filled.
Refrigerator
Fig. 13
17
Using RO
f
or Ice-maker only:
If
you want the RO to
f
eed your ice-maker (
f
ridge) only,
y
ou should still connect the RO
f
aucet
as
a
2n
d
ou
tl
e
t. This allows you to drain the tank,
f
lush new
f
ilters through the
f
aucet rather than
through your icemaker line. You can hang the
f
aucet by the system and not mount it.
Option
:
p
Multiple Outputs - Add Shut Off V
a
lve:
V
V
If
your RO is
f
eeding several output points (icemaker,
f
ridge, bathroom), you should add a
Shut-O
ff
valve to each output line (except the RO spigot line). This way, i
f
you ever need to
d
iagnose a problem in the system, you can easily shut o
ff
these lines to isolate the water
f
low
f
o
r
accurate troubleshooting.
B
all
V
al
v
e
(Recommen
d
e
d)
Tee

tti
ng
fo
r
i
cema
k
e
r
Option
:
p
I
ce
-m
a
k
e
r
Co
nn
ec
ti
on
If
you want to connect product water
f
rom the RO to your ice-maker, you will need
:
x
One T-
f
itting, pre
f
erably the quick-connect type
f
itting
x
Extra ¼ “ tubing long enough to go
f
rom the RO system to your ice-make
r
x
Optional: One shut-o
ff
valve, pre
f
erably the quick-connect type.
See
F
i
g.13. Be
f
ore connecting the product water line
f
rom Point
Z
t
o
H
, add a T-
f
itting nea
r
point H to divert product water to both the ice-maker and the
f
aucet. It is best open the line to
the ice make
r
after
the first tank has been discarded and the 2nd tank has completely filled.
r
R
e
f
rigerato
r
F
i
g. 13