Installation Guide

20
5) Check for leaks!
6) Drain the first tank of water (through faucet) to flush out the new membrane! The 2
nd
tank of
water is ready for use.
How to Replace Stage-6 Carbon Filter:
Replace this last filter at the same time you replace the stage-4 membrane.
1) Remove the OLD filter: See Fig. 14A. Disconnect the output tubing from point H and tubing at
point K. To remove the tubing, push in and hold down on the collet ring square against the fitting.
With the collet held in this position the tube can be removed.
2) Unclip the old filter from the membrane housing and discard the used filter.
3) Sanitize: Use some mild bleach solution to rinse the open ports of the new filter. This is to prevent
contamination.
NOTE: Only this filter change needs bleach sanitizing. Do not apply chlorine/ bleach in any way to
Membrane for it will damage the membrane!
4) Connect New Filter: See Fig. 14A. Attach the new filter onto the clips. Make sure the “FLOW Æ” arrow
on the filter is pointing towards the pure water output direction. Reconnect the UV light output point J,
to the inlet of the 6
th
stage carbon point K. Then, connect the output tubing to point H.
5) Check for leaks!
Fig. 14A
HK
J
Fig. 14B
20
5) Check
f
or leaks
!
6) Drain the
f
irst tank o
f
water (through
f
aucet) to
f
lush out the new membrane! Th
e
2
n
d
t
a
nk
of
water is ready
f
or use.
How to Replace Stage-6 Carbon Filter:
R
e
pl
ace this last
f
ilter at the same time
yo
u re
pl
ace the st
ag
e-4 membrane.
1) Remove the OLD
f
ilter: See Fig. 14
A
. Disconnect the output tubing
f
rom po
i
nt
H
and tubing at
po
i
nt K. To remove the tubing, push in and hold down on the collet ring square against the
f
itting.
With the collet held in this
po
sition the tube can be removed.
2
) Unclip the old
f
ilter
f
rom the membrane housing and discard the used
f
ilter.
3
) Sanitize: Use some mild bleach solution to rinse the open ports o
f
the new
f
ilter. This is to prevent
contamination.
N
OTE: Only this
f
ilter change needs bleach sanitizing. D
o
n
ot
apply chlorine/ bleach in any way to
M
embrane
f
or it will damage the membrane
!
4)
Connect New Filter: See Fi
g.
14
A
. Attach the new
f
ilter onto the cl
ip
s. Make sure the “FLO
W
Æ
”
a
rr
ow
o
n the
f
ilter is pointing towards the pure water output direction
.
Reconnect the UV light output po
i
nt
J
,
to the inlet o
f
the
6
th
stage carbon po
i
nt K. Then, connect the output tubing to po
i
nt
H
.
5
)
C
h
ec
k
fo
r l
ea
k
s!
Fig. 14
A
H
H
K
J
F
i
g. 14
B