Owner's Manual

3. The bypass valve comes complete with O-rings, split rings and black quick connector nuts. Install the

bypass valve by pressing the valve onto the head of the tank and hand tighten both black quick connect

nuts.

4. When running the piping for the Futura Water Conditioner, connect the incoming water supply to the UP-

FLOW INLET side. Connect the water supply line going into the house to the down-flow inlet side.

5. Use the appropriate fitting connections to the bypass valve. Brass Sweat Adapter Kit for copper piping

and PVC Solvent 90 degree Adapter Kit for PVC Piping. (Follow the instructions supplied with the fittings for

assembly)

a. Important: If soldering connections are used, do not install the O-rings, split rings and black

quick connector nuts until the soldering are done and given time to cool down. Heat from soldering

might damage plastic and rubber components.

b. Important: If PVC solvent connections are used, use solvent cements and primers to connect

fittings and piping. Allow solvent cements to set before installing the black quick connector nut, split

ring and O-rings.

INCOMING WATER SUPPLY

UPFLOW

DOWNFLOW

INLET

INPUT

OUTPUT

OUT GOING WATER TO HOUSE