System information

Camera Layout
Cycle Camera
Procedure Using the Remote Controller or Control Panel:
1. To view in sequence or to view slide show of the channels in Full Screen, press [CYCLE] on the
remote controller or [SELECT] on the control panel. Channel view changes every three (3) seconds by
default.
2. To exit, press on [CYCLE] or [SELECT] again.
3.Tocongurecycledelaytime,pleasegotoSETUP.
22
Picture-In-Picture (PIP)
Procedure Using Remote Controller:
1. When in Full Screen display, you may press
on [PIP] to view another channel in a smaller
window.
2. Press [1], [2], or [3] … to view camera 1, 2 or
3 in a smaller window.
3. Press [UP], [DOWN], [LEFT] or [RIGHT] to
move the smaller window.
4. To exit PIP, just press [PIP] again.
The PIP function is available only on the remote controller. Although, the [UP], [DOWN], [LEFT] and
[RIGHT] buttons on the control panel will be functional once the DVR is in PIP mode.
Procedure Using the Remote Controller:
1. In Full Screen, press ZOOM [+] to get a closer
view of the subject or to zoom in.
2. While zoomed in, press [UP], [DOWN], [LEFT],
or [RIGHT] to change the view of the zoomed in
area.
3. Press ZOOM [-] to zoom out.
Procedure Using the Control Panel:
1. In LIVE VIEW, press [MODE].
2. Select Zoom by pressing [UP]/[DOWN] and [SELECT].
3. While zoomed in, press [UP], [DOWN], [LEFT], or [RIGHT] to change the view of the zoomed in
area.
4. Press [BACK] to zoom out and go back to LIVE VIEW.
Digital Zoom
23