System information

Resolution
Resolution setup allows you to set recording
resolution per camera. This DVR supports
three different resolutions – CIF, Half-D1
and D1. The actual sizes of these resolu-
tions in pixels are described in detail in the
specications section which is found near
the start of this document.
The biggest resolution is D1. It is 2 times
bigger than Half-D1 and 4 times bigger than
CIF. D1 provides the most detail in the video
at the expense of bigger hard disk space
consumption.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select Recording->Resolution.
2. In Resolution Setup, use [UP], [DOWN],
[LEFT] or [RIGHT] to navigate through
the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change the values. In NTSC video signal
type, the possible values are 360x240,
720x240 and 720x480. In PAL, the pos-
sible values are 360x288, 720x288 and
720x576. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or
[BACK].
44
Audio
The Audio Setup menu sets the status of
audio recording for the DVR. Check the
status of the audio if you want audio re-
cording. Uncheck it if you want to disable
audio recording.
Use the Input Gain settings to increase or
decrease the volume of the input audio
signal.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select Recording->Audio.
2. In Audio Setup, use [UP], [DOWN],
[LEFT] or [RIGHT] to navigate through
the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change the value of the status. Use
[LEFT] or [RIGHT], [+] or [-] to change
the value of the input gain. Note that all
changes you make are always saved.
4. When you are done, press [SETUP] or
[BACK].
Schedule
You can set the recording policy of the DVR
per camera, by time of day, day of week
and by type of event. For each hour of the
week, you can choose from CONTINUOUS,
MOTION, SENSOR or EVENT recording.
In CONTINUOUS mode, the DVR will record all the time. In MOTION mode, the DVR will record only
when there is motion. In SENSOR mode, the DVR will record only when a sensor is triggered. In EVENT
mode, the DVR will record when either there is motion or a sensor is triggered.
45