System information

Notication

UnderEventNotication,youmaychoose

to be alerted by a red border, system beep*

and/or via SMS or email*.

(NOTE: *Some notications might not be available.)

Procedure Using the Remote Controller or Control Panel:

1. InSETUP,selectEvent->Notication.

2. Press [LEFT], [RIGHT], [+] or [-] to select a camera or ALL cameras.

3. Press [DOWN] to move to Red Border.

4. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck Red Border.

5. Press [DOWN] to move to SMS.

6. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck SMS. When checked, you may specify the

mobile number. The On-Screen Keyboard will appear automatically.

7. Use the On-Screen Keyboard to specify a mobile number.

8. Press [DOWN] to move to Email.

9. Press [LEFT], [RIGHT], [+] or [-] to check or uncheck Email. When checked, you may specify the

email address. The On-Screen Keyboard will appear automatically.

10.Use the On-Screen Keyboard to specify an email address.

11. Press [ENTER] or [SELECT] to save changes and exit. Or, press [SETUP] or [BACK] to exit without

saving.

Sensor

Under Sensor setup, you can modify

sensor settings, view sensor logs and

enable sensor onboard.

Procedure Using the Remote Control-

ler or Control Panel:

1. In SETUP, select Event->Sensor.

2. In Sensor Setup, use [UP], [DOWN], [LEFT] or [RIGHT] to navi-

gate through the menu.

3. Use [ENTER], [SELECT], [+] or [-] to change the values. The

status may be enabled or disabled. The normal state may either

be close or open. Note that all changes you make are always

saved.

4. When you are done, press [SETUP] or [BACK].

Under sensor logs, you can view the list of recorded information or

events collected by a sensor (or set of sensors).

It will automatically log the

sensor(s) that triggered and

the date it triggered.

Sensor On-board option de-

termines the sensors you are

using. Enabling it means you will use the built-in 4 sensors on the

board, while disabling it means you will use the 8 sensors in the

extended IO card (i.e. if you add an IO card to the board).