System information
50
Relay
Under Relay setup, you can modify relay
settings. A relay may be reset or returned
to its original state in 3 different ways
– time-based, sensor-synchronized or
manual. With time-based reset, the relay
will be reset after a specied duration(in
seconds). With sensor-synchronized, the
relay will be reset when the corresponding
sensor is reset. With manual reset, the re-
lay will be reset only with manual intervention.
Procedure Using the Remote Control-
ler or Control Panel:
1. In SETUP, select Event->Relay.
2. In Relay Setup, use [UP], [DOWN],
[LEFT] or [RIGHT] to navigate through
the menu.
3. Use [ENTER], [SELECT], [+] or [-] to
change the values. The reset mode
may be time-based, sensor-synchro-
nized or manual. Duration ranges
from 5 seconds to 60 seconds in
increments of 5 seconds. Note that
all changes you make are always
saved.
4. When you are done, press [SETUP] or [BACK].
Motion
Motion settings allow you to select area or
adjust zones of motion detection for each
camera. The image below shows all areas
are selected for motion detection.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select Event->Motion.
2. Select a camera using [LEFT],
[RIGHT], [+] or [-], then press [ENTER]
or [SELECT].
3. In Motion Setup, use [UP], [DOWN],
[LEFT] or [RIGHT] to select zones.
4. Using the remote controller, you can
change the selected camera by press-
ing any of the number buttons. Press
zero (0) to select all cameras.
5. Use [ENTER], [SELECT], [+] or [-] to
add or remove the selected zone. Note
that all changes you make are always
saved. Use [Focus +] or [Focus -] to
add or remove contiguous zones.
6. When you are done, press [SETUP] or
[BACK].
Mappings
Mappings are used to map or relate sen-
sors to cameras, sensors to PTZ cameras,
sensors to relays and cameras to relays.
Mappings provide the means for the DVR
to react on certain events.
When a sensor is mapped to a camera, a
change in the state of the sensor will cause
the camera to start recording.
When a sensor is mapped to a PTZ cam-
era, a change in the state of the sensor
will cause a PTZ camera to activate a
preset.
When a sensor is mapped to a relay, a
change in the state of the sensor will cause
the relay to change its state as well.
Lastly, when a camera is mapped to a
relay, a motion event in the camera will
cause the relay to change its state.
51