System information

Video Lost to Relay

This mapping allows you to activate your

relay(s) when there is no video signal.

Procedure Using the Remote Controller

or Control Panel:

1. In SETUP, select Mappings->Video Lost

To Relay.

2. In Video Lost to Relay Setup, use [UP],

[DOWN], [LEFT] or [RIGHT] to navi-

gate through the menu.

3. Use [ENTER], [SELECT], [+] or [-]

to change the values. An “x” means

mapped or activated. Note that all

changes you make are always saved.

Note: You can map more than 1 camera per re-

lay. Conversely, you can map more than 1 relay

per camera.

PTZ

Before a Pan-Tilt-Zoom (PTZ) camera

can be operated using the DVR, certain

parameters must be set. You may need to

consult the manual of your PTZ camera

for details about the physical connection

with the DVR.

Procedure Using the Remote Controller or Control Panel:

1. In SETUP, use [UP] or [DOWN] to select PTZ.

2. Press [ENTER], [SELECT] or [RIGHT] to expand the sub-menus.

3. To view/modify settings under the sub-menus, use [UP] or [DOWN] to select the sub-menu and

press [ENTER] or [SELECT].

4. In the sub-menu, navigate by pressing [UP] or [DOWN], [LEFT] or [RIGHT] to choose which option

to modify.

5. Press [ENTER] or [SELECT] to select a sub-menu.

Comm Settings

You must set the Baud Rate, Data Bit,

Parity and StopBit to follow the settings

of your PTZ camera so that the DVR

can control it properly. Check your PTZ

camera’s manual for the recommended

values.

Procedure Using the Remote Controller or Control Panel:

1. In SETUP, select PTZ->Comm Setting.

2. In Comm Setting, use [UP] or [DOWN] to navigate through the menu.

3. Use [LEFT], [RIGHT], [+] or [-] to change the values. Make sure the values you select match the

specicationsofthePTZcamera.

4. Press [ENTER] or [SELECT] to save and exit. Or, press [SETUP] or [BACK] to exit without saving.