System information

Camera
Under Camera settings, you can indicate
which camera is a PTZ camera. For PTZ
cameras, you must indicate the communi-
cation protocol used by it.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select PTZ->Camera.
2. In PTZ Camera Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navigate
through the menu.
3. Use [ENTER], [SELECT], [+] or [-]
to change the values. If the status is
checked, the camera is a PTZ camera.
The protocol may either be Pelco-D,
Pelco-P, DynaColor, Merit Li-Lin, Sony
Visca. Note that all changes you make
are always saved.
4. When you are done, press [SETUP] or
[BACK].
PTZ Speed
You may adjust the panning/tilting speed,
zooming speed and focusing speed of
your PTZ camera. Note, however, that not
all PTZ cameras have all 3 speed controls.
Check your PTZ camera manual to verify.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select PTZ->Speed.
2. In PTZ Speed Setup, use [UP] or
[DOWN] to navigate through the menu.
3. Use [LEFT], [RIGHT], [+] or [-] to change
the values.
4. Press [ENTER] or [SELECT] to save and exit. Or, press [SETUP] or [BACK] to exit without saving.
56
Presets
This function enables the user to access/
modify presets. Note that you will not be
allowed to use this function if no PTZ cam-
eras are connected.
Procedure Using the Remote Controller or Control
Panel:
1. In SETUP, select PTZ->Presets.
2. In Presets Setup, use [UP] or [DOWN] to navigate
through the menu.
3. Use [LEFT], [RIGHT], [+] or [-] to change the values.
4. When you check a preset, press [ENTER] or [SELECT]
to set the position of the PTZ camera. After pressing
[ENTER] or [SELECT], [UP], [DOWN], [LEFT] and
[RIGHT] will move the camera position. Use [+], [-],
[MODE] and [BACK] to zoom in or out.
5. After you have positioned the camera to the desired
view and zoom, press [ENTER] or [SELECT]. You will
be able to navigate the menu again as explained in item
#2.
6. When you are done, press [ENTER] or [SELECT] again to exit and save changes. Or, press [SET-
UP] or [BACK] to exit without saving.
Language
Language setup allows you to choose which
language the system will use.
Procedure Using the Remote Controller
or Control Panel:
1. In SETUP, use [UP] or [DOWN] to select LANGUAGE.
2. Press [ENTER], [SELECT] or [RIGHT] to expand the sub-menu.
3. To select a language, press [ENTER], [SELECT], [+] or [-].
4. Press [LEFT] to go back to the main selection. Or, press [LIVE VIEW] to exit SETUP.
English is the language used by default. Other languages available are the following: Traditional Chinese, Simplied
Chinese and Portuguese.
57