System information

Sensor PTZ Mapping
1. Map Preset – Indicates if the sensor will be mapped to a PTZ preset when it is triggered. If this is
unchecked, then the Camera, PTZ On, PTZ Off and Dwell Time options are also disabled.
2. Camera – Displays a drop down list menu of available cameras that can be called when the sensor
is triggered.
3. Preset On – Displays a drop down list menu of available presets from the selected camera that can
be called when the sensor is triggered.
4. Preset Off – Displays a drop down list menu of available presets from the selected camera that can
be called when the Dwell Time length has been reached.
5. Dwell Time – Indicates the length in seconds on how long the PTZ will remain in the Preset On posi-
tion before going to the Preset Off position.
6. Restore Defaults – Restores the default settings.
7. Apply – Saves the settings.
78
Motion Mapping
1. Mapping –Indicatesthemappingthathavebeenset.An“X”signiesamappingexistswiththe
corresponding camera and relay.
2. Restore Defaults – Restores the default settings.
3. Apply – Saves the settings.
Map Camera Motion
1. To map the cameras to relays, click on the grid to place a mapping. Click on the grid to place an “X”
to mark the camera-relay mapping. Once a camera has been mapped to a relay, this means that
when that particular camera detects motion, the relay which is mapped to that camera will either
open or close. NOTE: You can map one camera to more than one relay and vice versa. When
applied, this means that when motion is detected in any of the cameras, the relay that is mapped to
these cameras will open or close, i.e. light will turn on.
2. To apply settings, click on the Apply button.
79