Owner`s manual

Test for leaks at this point: Close the Needle Valve (turn needle handle clockwise all the

way in to close) Turn ON the cold water supply to the sink faucet. If the Needle Valve or the

Adaptor leaks, check the connection and try applying more Teflon tape or tighten the brass

nut some more to stop the leak.

Step 2: Drain Saddle Installation

Note: To avoid annoying drainage noise, mount drain line as low as possible

on the vertical tailpiece, or on horizontal tailpiece.

There is constant water pressure “packed” inside the RO system which blocks the waste water

from backing-up into the system. So the waste water is “forced-drained”, not “gravity-drained”.

1. See Fig. 6. The drain saddle assembly should be installed above the trap and on the vertical

or horizontal tailpiece . To reduce the drainage noise, mount the drain line as low as possible

above the trap, or on the horizontal tailpiece.

Fig. 6

2. See Fig.7. Mark the position of the hole on the drain pipe and drill a 1/4’’ hole through one

side of the drain pipe . There is a piece of self-adhesive sponge provided. Glue this sponge

to the inside of the saddle, this will cushion any gap between the saddle and the pipe. Make

sure the hole on the sponge is thoroughly punched out, and is aligned to the hole on the

saddle.

Fig.7 Fig.8

MOUNT DRAIN

SADDLE AT

EITHER

LOCATION