Owner`s manual

Tubing color: Clear tubing. Connect the CLEAR tubing from the faucet base stud to the Stage-5 filter’s

outflow end at point H. (See “Flow -->” arrow on the filter for flow direction.)

Fitting type: Plastic compression nut fitting with built-in sleeve. No teflon tape needed here.

6. Point G Stage-5 filter’s T-fitting connection:

Tubing color: Yellow tubing. Connect the YELLOW tubing to Stage-5 filter’s T-fitting.

Fitting type: Plastic compression nut fitting with built-in sleeve. No teflon tape needed here.

7. Point Y Tank’s input & output connection:

Prepare tank: See Fig. 12. Apply Teflon tape to tank’s threaded Output stem on top of tank (remove

rubber cap if there is one).

Screw tank Valve onto Output stem.

Tubing color: Yellow tubing. Connect the YELLOW tubing from Stage-5 T-fitting to the tank’s valve.

Fitting type: Quick-Connect fitting on ball valve. Simply push Yellow tubing into valve port.

Standard 4-gallon Tank Diagram:

Tank Ball Valve

Fig. 12

OFF Position ON Position

Option: Ice-maker Connection

If you want to connect product water from the RO to your ice-maker, you will need:

 One T-fitting, preferably the quick-connect type fitting

 Extra ¼ “ tubing long enough to go from the RO system to your ice-maker

 Optional: One shut-off valve, preferably the quick-connect type.

See Fig.11. Before connecting the product water line from Point Z to H, add a T-fitting near

point H to divert product water to both the ice-maker and the faucet.