Datasheet

ManualsBrandsAPEM ManualsPush Actuated Switches & ButtonsTamper-proof pushbutton 30 Vdc 1 A 1 x Off/(On) IP67 momentary 1 pc(s)

The company reserves the right to change specifications without notice.

AV series

• Max. current/voltage rating with resistive load : 1 A 30 VDC

• LED voltage : 12 VDC, 24 VDC or 48 VDC

(If not supplied by APEM, a resistor must be series-connected

by the user)**

• Initial contact resistance : 100 mΩ max.

• Insulation resistance : 10 MΩ min. at 500 VDC

• Dielectric strength : 500 Vrms 50 Hz min. between terminals

1,000 Vrms 50 Hz min. between terminals and frame

• Electrical life : 250,000 cycles at full load

ELECTRICAL SPECIFICATIONS

**Resistor value = supply voltage - LED forward voltage

LED forward current

Large actuator

With illuminated ring

Momentary NC/NO

Solder lug, flying lead or cable terminals

Marking available on request

DISTINCTIVE FEATURES

• Optional front panel sealing : IP67 according to IEC 60529

• Robustness : IK06 according to EN 62262 (1 joule)

• Operating temperature : -30 °C to +85 °C (-22 °F to +185 °F)

ENVIRONMENTAL SPECIFICATIONS

Security pushbutton switches •

Ø 30 mm • illuminated momentary NC/NO

• Travel : 2.5 mm ± 0.3 mm (.003)

• Operating force : 5 N ± 2 N

• Torque : 10 Nm max.

• Panel thickness : 1 (.039) to 6 mm (.236) max.

• Low level or mechanical life : 1,000,000 cycles

• Hand soldering : 350 °C (662 °F), 5 seconds max.

GENERAL SPECIFICATIONS

PANEL SWITCHES

SW-AV30NCNO-1709

Summary of content (5 pages)

PAGE 1
AV series 0N V3 -A SW PANEL SWITCHES O CN 9 70 -1 Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO DISTINCTIVE FEATURES Large actuator With illuminated ring Momentary NC/NO Solder lug, flying lead or cable terminals Marking available on request ENVIRONMENTAL SPECIFICATIONS • Optional front panel sealing : IP67 according to IEC 60529 • Robustness : IK06 according to EN 62262 (1 joule) • Operating temperature : -30 °C to +85 °C (-22 °F to +185 °F) ELECTRICAL SPECIFICATIONS •
PAGE 2
PANEL SWITCHES AV series Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO MATERIALS • Case : polyamide, glass filled • Contacts : silver • Bushing : see following pages • Actuator : see following pages • Elastomeric membrane : silicone • LED ELECTRICAL FUNCTIONS CAV3-9FCT NC/NO ECHELLE 1 MOUNTING • Panel cut-out : Ø 30.2 mm (1.189) • Min. pitch for matrix mounting : 44 mm x 44 mm (1.732x1.
PAGE 3
Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO BUILD YOUR PART NUMBER BASIC PART NUMBER AV SERIES BUSHING DIAMETER 5 30 (1.
PAGE 4
Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO Plastic hex nut 36 (1.417) across flats 2.20 (.086) 36.00 (1.417) + + - Non-illuminated _ AV50022 + - 5.00 (.197) NC NO 24.00 (.945) 8.30 (.326) * Select LED color on previous page - No LED resistor supplied on this model. Illuminated* AV5••2F + - + - CAV5DT-1 ech : 0.8 Plastic hex nut 36 (1.417) across flats 2.20 (.086) 12.40 (.488) Ø30.00x1.50 SI (1.181DIAx1.50 IS) Ø25.00 (.984DIA) Ø34.00 (1.
PAGE 5
Security pushbutton switches • Ø 30 mm • illuminated momentary NC/NO FLYING LEAD PROTECTION BASIC P/N 0 1 2 No protection and/or no flying leads Heat-shrink sleeves Tube + epoxy FLYING LEAD/ CABLE LENGTH BASIC P/N 000 020 XXX No flying leads / no cable Length 20 cm (standard) Length in centimeters RING COLORS BASIC P/N 1 2 3 4 5 6 7 8 9 Blue Black * Green Grey * Yellow Red Opal white (std) Translucent Orange * non-illuminated only BUSHING/ACTUATOR MATERIALS BASIC P/N CODE BUSHING ACTUATOR 00 (