Datasheet

ManualsBrandsAPEM ManualsSwitches & ButtonsJoystick 125 Vac Lever (straight) Soldering IP67 1 pc(s)

APEM www.apem.com

Note: The company reserves the right to change specifications without notice.

NZ series

Compact switch joysticks

Distinctive features and specifications

 Compact Size

 11.9mm Bush Mount

 Alternate Handle Selection

 Polyimide Flexi Tail Option

 Silicone Rubber Sealing Boots

 V5 switches up to 2A

ELECTRICAL

• Nominal Current Switch Option A: Up to 2A

• Nominal Current Switch Option B: Up to 100mA

• Maximum Voltage: 125VAC

• Switch Contacts: Changeover gold plated silver alloy

• Contact Life: Load Dependent (Please refer to factory)

ENVIRONMENTAL

• Temperature Range Switch Option A: -25ºC to +50ºC (-13ºF to +122ºF)¹

• Temperature Range Switch Option B: -40ºC to +85ºC (-40ºF to +185ºF)¹

• Above Panel Seal-Lever / Boot options A and B: To IP67

(IP Ratings quoted refer to assembled joysticks with boots fitted, and are

above panel seals only).

Connection

0 No harness

1 Polyimide Tail 5 Way

2 Polyimide Tail 12 Way

Lever / Boot

A Half Boot + Lever

B Full Boot + Lever

Z Specified

Modifier

00 None

135 + Limiter Fitted

Switches

A Standard

B Sealed

SERIES

NOTES:

– All values are nominal.

– Specifications are subject to the joystick configuration.

Contact Technical Support for the performance of your specific configuration.

1. Temperature specifications may be subject to the chosen switch option.

Please refer to factory.

MECHANICAL

• Mechanical Life: 1 Million Operations (maximum)

• Lever Travel: 15º (±7.5º from center)

• Lever Material: Stainless Steel

• Weight: 35 to 45 grams (subject to configuration type)

• Body Material: Mineral Filled Nylon-6

• Boot Material: Silicone rubber

• Mounting - Bush: Single Point 11.9mm Diameter

• Recommended Panel Thickness (for half boot): 1-4 mm – suggested 3mm

• Recommended Panel Thickness (for full boot): 1-4 mm – suggested 2mm

• Impact Test Rating: IK09 (Lever / Boot options A and B)

Summary of content (3 pages)

PAGE 1
NZ series Compact switch joysticks Distinctive features and specifications  Compact Size  11.9mm Bush Mount  Alternate Handle Selection  Polyimide Flexi Tail Option  Silicone Rubber Sealing Boots  V5 switches up to 2A MECHANICAL • • • • • • • • • • Mechanical Life: 1 Million Operations (maximum) Lever Travel: 15º (±7.
PAGE 2
NZ series Compact switch joysticks Overview JOYSTICK MOUNTING (ALL VERSIONS) NOTE: Both full and half boots to be tightened to 1.5Nm to ensure the optional panel gasket is fully compressed. If extra security is required, use an appropriate bond to secure the nut to the bush. Take care when fitting boots over levers, ensuring they are not twisted, once installed. NZ WITH FULL BOOT NZ WITH HALF BOOT N N Ø36.00 (1.
PAGE 3
NZ series Compact switch joysticks Overview SWITCHES The NZ series is supplied with two switch options. Both options have a gold plated silver alloy contact, providing reliable switching at low current levels. Switch option A being suitable for up to 2A operation and switch option B being suitable for 100mA operation. The anticipated life of the switches is heavily determined by the application and parameters such as load type.