Installation Instructions

June 2013 10 80-0180-347 Rev. A
STEP 2 SPINDLE PREPARATION
(For 1-3/4” doors)
For Adams Rite MS1850 Deadbolts, 4500/4900 Deadlatches, &
8000 Series Mortise Exit Devices:
Snap-off spindle at fifth (5th) notch as shown in FIG. 4. For 2” thick
door add one notch.
For Adams Rite 8600 Concealed Vertical Rod Exit Devices:
Snap-off spindle at sixth (6th) notch as shown in FIG.5. For 2” thick
doors add two notches.
For Adams Rite 8000 Series Surface Vertical Rod & Rim Exit De-
vices, Yale 7200 Series Narrow Stile Exit Devices, Corbin Russ-
win ED4000 Series, and SARGENT 8500 Narrow Design Rim Exit
Devices: Snap-off spindle at fourteenth (14th) notch as shown in FIG.
6. For 2” thick doors add two notches.
FIG. 6
Insert “T”
end into
exit devices
Fourteenth notch
FIG. 5
Sixth notch
Insert Flat
end into
exit devices
FIG. 4
Fifth notch
Insert Flat
end into
exit devices
June 2013 11 80-0180-347 Rev. A
STEP 3 CONFIGURE FOR LOCK SERIES
Mortise Latch Application: A100-3090H for 4500/4900
(including 8300/8400 Exit Devices)
Configure the supplied cam plug to match the hand of door. Insert
into latch case with notch on the cam plug aligned with latch case set
screw. Tighten set screw and secure with the two brass cam plug
screws.
CVR Exit Device Application:
A100-3090H for 8500/8600
Install Tailpiece adapter on the vertical rod and fasten with Phillips
screw as shown.
FIG. 9
Note: Devices manufactured before 1997 will not accept the tail piece adapter
Left Hand
Reverse (LHR)
FIG. 7
Right Hand
Reverse
(RHR)
FIG. 8