Installation Instructions

ManualsBrandsAperio ManualsElectronicsKeyless Entry and Hub Wholesale Kit with Prox Reader for Exit Device Only in Dark Bronze

June 2013 2 80-0180-347 Rev. A

Table of Contents

Warning .............................................................................................. 3

Definitions ........................................................................................... 3

System Overview ............................................................................... 4

Operational Description ...................................................................... 5

Hub Location ...................................................................................... 6

Hub Wiring .......................................................................................... 7

Trim Installation Tools & Equipment .................................................. 8

Door Preparation ................................................................................ 9

Spindle Preparation .......................................................................... 10

Lock Series Configuration ................................................................ 11

Handing the eForce

........................................................................ 13

Mortise Cylinder Installation ............................................................. 14

Rex/DPS Cable Installation .............................................................. 15

Mounting the eForce ........................................................................ 16

Battery Installation ............................................................................ 17

Limited Warranty .............................................................................. 18

Troubleshooting ............................................................................... 19

LED Indications ................................................................................ 20

June 2013 19 80-0180-347 Rev. A

TROUBLESHOOTING

The eForce A100 LED is normally off until a credential is presented

and then LED will momentarily turn green if credentials are valid. A

red LED will show if credentials are not valid.

 Place known credential card in front of eForce

 If the eForce

emits one short tone, but lock does not activate,

check Wiegand data lines for connectivity and proper connec-

tion.

Green light comes on, but lever will not retract latch or deadbolt:

 Check the eForce

body connection with lock/latch mechanism.

 Check the spindle length (see installation instructions).

 Check for proper door preparation (refer to door templates).

No lights come on and Operator stays unlocked (unsecured):

 Ensure credential card matches reader type (iCLASS or PROX) if

they do not match, the card will not trigger the eForce reader.

 Check the eForce

body connection.

 Check battery level, replace if necessary.

 Check that the Battery cover is installed and secured.

Credentials not activating lock:

 Trigger access control system to unlock the device.

 If this unlocks the lock:

 Ensure that credentials are in system database.

 Refer to additional EAC documentation.