Installation Instructions

June 2013 16 80-0180-347 Rev. A
STEP 7 Mounting the A100-3090
 Insert the properly dimensioned
spindle into the output hub.
 Mount the A100 onto the mount-
ing bracket and guide the spindle
into the Cam Plug.
 The A100 must sit flush on the
door surface.
 Secure with two (2) #10-32 x
5/8” screws as shown.
FIG. 20
FIG. 19
FIG. 21
SPINDLE
June 2013 5 80-0180-347 Rev. A
OPERATIONAL DESCRIPTION
When the eForce
®
is in a secured state, the LED in the front plastic faceplate
will be off, and the lever will not operate the locking mechanism.
Credential Card Operation
When a user presents a supported credential to the lock, the Aperio system is
designed to send the credential wirelessly to the Aperio Hub. The Aperio
Hub then communicates with an EAC system. The EAC system provides the
access decision to the Aperio Hub where access to the lock is either granted
or denied.
To gain entry using an iCLASS or Prox Card:
 Place card in front of the small plastic cover, at a distance no greater
than one inch.
 The access control system will receive the card
credential information, and will send an unlock
signal to the eForce
®
if the credentials are valid.
 The LED will change states from off to green, and
a short audible tone will be heard to indicate a
valid unlock status.
 Rotate the lever to gain entry into the building.
 Deadlatch versions will return to a secured locked
state after the access control system unlock pe-
riod has expired. Deadbolt versions will remain
unlocked until the deadbolt is thrown again.
NOTE: the access control system will determine
the unlock period. There are no adjustments in
the eForce
®
for unlock period.
Adding Card Credentials
Consult the access control system manual or the sys-
tem administrator to manage your credential data-
base. The eForce
®
does not store card credentials; it
simply extracts the information from the card and
sends it to the access control system for verification.
Lock & Hub Pairing
The eForce A100-3090H is paired with the communication hub that is in-
cluded in the same box. Locks and hubs cannot be interchanged in the field.
If either the eForce A100-3090H or the communication hub require replace-
ment, both parts will need to be replaced at the same time.
Manual Operation – Key Cylinder
1. Insert key into lock cylinder.
2. Turn the key 180° to the detent position and hold.
3. Rotate the lever until latch or deadbolt clear the strike and open the door.
4. Return the key to the 12 o’clock position and remove the key.