Installation Instructions

June 2013 6 80-0180-347 Rev. A
HUB LOCATION
Choose the Hub location
The hub should be mounted near the top of a wall, on the ceiling or
above the ceiling to reduce potential for interference.
For a stable and reliable radio link, it is recommended that the hub is
located within fifty (50) feet of the lock. A maximum of two interior
walls between the hub and
lock is recommended
Recommended locations:
A: Wall Mount
B: Ceiling Mount
C: Above Ceiling Mount
*Note the Hub is not
rated for use in Plenum
spaces
Mounting the Hub
The included hub mounting adapter plate can be used to mount the
hub on a single or double gang box.
A
B
C
June 2013 15 80-0180-347 Rev. A
STEP 6 REX/DPS CABLE INSTALLATION
PIN #
WIRE COLOR
FUNCTION CONTACT
1
Yellow
D.P.S.
(Door Position
Switch)
N.C.
2
Blue COM
3
Brown N.O.
4
Orange N.C.
REX
(Request to Exit)
5
White COM
6
Green N.O.
 Using a Phillips Head screwdriver, remove the eight (8) #10-32 x
5/8” screws on the back of the eForce and gently lift the back plate
off the housing. (Fig. 16).
 Plug the Rex/DPS cable into the board and run the other end of the
cable through the grommet and out of the backplate as shown in
Figure 17.
 Gently place back plate on housing and secure with eight (8) #10-32
FIG. 16 FIG. 17 FIG. 18