Installation Instructions

June 2013 12 80-0180-347 Rev. A
RIM Exit Device Application: A100-3090H for 8700/8800
 On the back side of the exit device, re-
move only the lower Phillips head screw,
depending on hand of door, to free up the
cylinder actuator for use. (FIG. 10)
MS 1850 Application: A100-3090H for
MS
®
Series Deadbolt
 Two (2) brass hex head screws and the
set screw from the MS1850 will fasten
the cam plug to the MS1850. (FIG. 11)
 For MS
®
Deadbolt, insert Cam Plug (FIG.
12) into lock case with notch on the cam
plug aligned with lock case setscrew.
 Tighten setscrew and secure with the
two (2) brass cam plug screws. Cam
Plug must be positioned below door sur-
face.
CYLINDER ACTUATOR SCREW
FIG. 11
FIG. 10
FIG. 12
June 2013 9 80-0180-347 Rev. A
STEP 1 DOOR PREPARATION
FIG. 2
 Select the stick-on template to match the appli-
cation.
 For Yale, Corbin Russwin and SARGENT exit
devices, use template 80-0180-396-01.
 Mark the backset and horizontal centerlines.
 Apply clear template over the centerline marks
(FIG. 2).
 Center-punch four (4) referenced mounting
holes and remove template.
 Drill holes at center-punch locations using a ¼”
drill bit.
 Install Rivnuts. Refer to instructions supplied in
Rivnut kit.
 Install mounting bracket (Item 1) with two (2)
each of #10-32 x 5/8” (Item 2) Phillips pan
head screws. (FIG. 3)
FIG. 3