User's Manual

CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
6–24070-20000340-01 Rev A
SUBSCRIBER CONFIGURATION
To configure subscriber equipment, click on the CPE icon on the WaveCenter Con-
figuration Manager home screen (Figure6-1). The CPE Configuration Manager will
open in a new window, as shown in Figure6-12.
There are nine tabs for subscriber equipment configuration, as shown in Figure6-12:
• System — Used to specify basic information about the subscriber equipment.
• SNMP — Used to control SNMP access to the subscriber equipment.
• Packet Filter — Not supported in R1P1.
• Service Flow — Used to define Service Flows for the subscriber.
• Classifier — Used to specify the classifiers that will cause packets to be
assigned to the various Service Flows.
• Routing — Not supported in R1P1.
• Alerts — Used to configure the subscriber equipment for email event alerts.
• NAT — Used to configure a subscriber Indoor Unit’s NAT routing.
• DHCP — Not supported in R1P1.
Figure6-12 CPE Opening Menu (System)