User's Manual

CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
6–38070-20000340-01 Rev A
Configuring the Subscriber Indoor Unit’s DHCP Server
This menu is not supported in R1P1.
Table6-R CPE — NAT Parameters
Parameter Range
(and Default)
Comments
LAN IP Address xxx.xxx.xxx.xxx decimal
(192.168.2.1)
Enter the IP address of the subscriber Indoor Unit’s
Ethernet LAN interface. This will be the default gate-
way for the LAN and will typically follow the gateway
addressing convention.
LAN Mask xxx.xxx.xxx.xxx decimal
(255.255.255.0)
Enter the subnet mask which defines the LAN
subnet.
Visible Host xxx.xxx.xxx.xxx decimal
(no default)
Enter the IP address of a host on the LAN which will
respond to the subscriber Indoor Unit’s wireless
interface IP address.
Enable Port Translation checked or unchecked
(checked)
Check the NAT Port Translation box to enable port
translation; uncheck the box to disable.
Apps to be diverted to
PacketWave 130
Web (checked)
Telnet (unchecked)
SNMP (checked)
Check boxes corresponding to applications which
are to be diverted to the PacketWave 100.
Existing Servers (Drop-down menu) Menu of servers defined on the LAN subnet.
Server Type FTP, HTTP, IMAP2,
SNMP, POP3, SMTP,
Telnet, TFTP, Other
(no default)
Use these fields to define (add or delete) servers on
the LAN subnet, and to specify the parameters of
the servers.
Local Port Number Read-only, per Server
Type
Remote Port Number Default follows Local
Port Number
Local Server IP Address xxx.xxx.xxx.xxx decimal
(192.0.1.0)
Protocol Type (Drop-down menu)
Configuration Operation Add or Delete
(Add)