User's Manual

7–5070-20000340-01 Rev A

CHAPTER 7. NETWORK CONFIGURATION AND START-UP

YSTEM

TART

-U

Once all of the configuration files have been created, start the PacketWave System by

performing the following steps:

1. Verify that all of the configuration files have been saved in the default directory

on the TFTP server.

2. Verify that the TFTP server is running and accessible.

3. Verify that the DHCP server has been configured for network addresses and for

all BSUs and subscribers.

4. Verify that the DHCP server is running and accessible.

5. Boot the Base Station Unit. It will download its configuration, obtain its IP

address, and initialize automatically.

6. When the Base Station Unit has finished initializing, boot the subscriber Indoor

Units.

7. Initialize each subscriber Indoor Unit using the CPE Installation Tool, as

described in the PacketWave 100 Series Subscriber Equipment Installation and

Operation manual. When a subscriber Indoor Unit has been initialized, it will

download its configuration, obtain IP addresses, and join the network.

DDING

ASE

TATION

NITS

AND

UBSCRIBERS

To add one or more Base Station Units and/or subscribers to an existing cell:

1. Launch the WaveCenter Configuration Manager.

2. Use the Configuration Manager to create configuration files for the new

device(s) as described in Chapter 6.

3. Save or copy the configuration file(s) to the default directory of the TFTP

server.

4. Add the required information about the device(s) in the DHCP server’s config-

uration file.

5. Boot the new devices.