User's Manual

CHAPTER 6. BSU AND S UBSCRIBER CONFIGURATION
6–18070-20000340-01 Rev A
Table6-G BSU — MAIN — General Parameters
Parameter Range
(and Default)
Comments
Cell Name Up to 79 characters
(no default)
Enter the name chosen for the cell served by the
BSU.
Cell Radius 1000 to 50000 meters
(5000)
BSU Location Up to 79 characters
(no default)
Enter text identifying the location of the BSU.
BSU Name Up to 79 characters
(no default)
Enter the name chosen for the BSU.
BSU Contact Up to 79 characters
(no default)
Enter contact information regarding the BSU.
MAC Address 00:01:3b:xx:xx:xx
(no default)
Complete the MAC address of the BSU as identified
by a label on the BSU. (All Aperto MAC addresses
begin with 00:01:3b.)
Required field.
System Image File file name Identifies the system software which should be run-
ning on the BSU. If different software is running, the
BSU will attempt to download the specified software
from the TFTP server.
WSS Image File file name Identifies the WSS software which should be run-
ning on the BSU. If different software is running, the
BSU will attempt to download the specified software
from the TFTP server.
SNTP Configuration Enable or Disable
(Enable)
Specify whether the BSU will obtain date and time
from an SNTP server. (The SNTP server is specified
in the DHCP server configuration.)
Time Zone Drop-down menu of
time zones worldwide.
Select the appropriate time zone from the drop-
down menu.
Daylight Saving Enable or Disable
(Disable)
Specify whether daylight saving time will be
observed.
Daylight Saving Start mmddhh
(no default)
Enter the date at which daylight savings time will
start.
Daylight Saving End mmddhh
(no default)
Enter the date at which daylight savings time will
end
Configured WSS Ports (drop-down menu) Read-only field identifying the number of WSS ports
which have been configured (using WSS menu set
and Generate WSS Config button).
Total WSS Ports 0 to 6
(0)
Specify the number of WSS ports to be configured.