User's Manual

Chapter 2. Installation and Configuration
2–4
070-20000750-01 Rev A
If you feel you are connected properly between the PC and the PW620,
see below for other errors.
Click on the Next button at the bottom of the window. You will move to the next window
and AIM will begin communications with the PW620. It will read the type of IDU so that it
may proceed correctly through this installation.
Figure 2-2 Authentication Window
Choose the Installation Mode
You should now be at the Installation Option Window as shown in Figure 2-3 below. You
may now choose Setup to perform an Installation viewing and changing the parameters or
Continue to use the parameters that are already stored in the PW620 from a previous
installation attempt. If in doubt, choose the Setup option. Select the Installation Mode
Option and then click on the Next button at the bottom of the window. If you chose the
Setup Option, continue the instructions below. If you chose the Continue with setup