User's Manual

2–5

070-20000750-01 Rev A

Chapter 2. Installation and Configuration

Option, skip then next step and go to the Continue Configuration Description. As you con-

tinue on the next window, AIM will get the current parameters from the PW620.

Figure 2-3 Installation Option Window

Fill Out the Configuration Parameters

If you are here, you chose the Setup Installation mode. If you chose the Continue with

setup option please skip to the next step.

The information shown to you in the Configuration Window was retrieved from the

attached Aperto unit. If you have any reason to believe these are not correct, click on the

Previous button and then on the Next button to get back to this screen and refresh the

data.

You should now be at the Installation Option Window as shown in Figure 2-4 below. Most

of the values are filled in for you. The MAC address should be the same as that on the

label in the back of the IDU.

If this is the first time, the window will look differently than in each successive installation.

That is because the frequency band and channel width are only requested once. Please

use the selection box following the “Frequency (MHz)” label to select the UNII5.8GHz

Se tup - new parameters

Continue - reset the unit.