User's Manual

2–17
070-20000750-01 Rev A
Chapter 2. Installation and Configuration
These results and RF transmission results are recorded in a text file with the name of the
IP address in the file in which AIM is loaded (normally C:\aim). Each time the Setup or Test
function successfully executed this file is updated.
View the Results and Re-align the Antenna if Necessary
It is important to check the RF and IP transmission results to see if you have the best pos-
sible wireless connection. If these results are not acceptable, click on the previous button
to the installation option window, choose the Continue with Setup option and click on
next and then final buttons to re-align the antenna and retest.
Exit the AIM Application
To exit, click on the Exit button. An exit confirmation window will appear as shown in
Figure D-14 on page -18.
Running a Non-destructive Test
You can run a non-destructive test at any time from the LAN port of the PW610. Connect
the PC to the PW610 and start the AIM application as described above. At the Installation
Option Window, select Test only and click on the Next key. You can pick the number of
megabytes to be transferred from the selection window shown below in Figure 2-13. Click
on the Next button after choosing the size of the test.
Figure 2-13 Test Configuration Window