User's Manual

4–15
070-20000750-01 Rev A
Chapter 4. Subscriber Unit Web GUI
E-mail Configuration Page
The E-mail Configuration page, shown in Figure 4-14, allows the viewing and altering of E-
mail event reporting parameters:
• Whether event reporting via E-mail is enabled or disabled.
• The address of the SMTP server.
• The E-mail domain name.
• Reply-to and receiver E-mail addresses.
• Whether a test E-mail will be sent when the Submit button is clicked on.
Click on the Submit button to activate any changes made on this page.
Status Pages
There are two status pages:
• The System Status page, shown in Figure 4-15, identifies the Indoor Unit, its soft-
ware and hardware, and its current operational status.
• The Link Status page, shown in Figure 4-16, provides information about the wire-
less link between the subscriber equipment and the base station.
System Status is available at both ISP and subscriber levels; Link Status is available at
the ISP level only.
Performance Pages
Performance pages, available at the ISP level only, include:
• The System Statistics page (Figure 4-17) shows counts of packets and bytes trans-
mitted and received on the wireless link.
•The RF Signal Quality page (Figure 4-18) shows RF signal performance statistics
such as burst error rate and FEC error counts.
• The Filter Statistics page (Figure 4-19) shows counts of passed and blocked pack-
ets; hyperlinks allow selection of Ethernet or wireless interface statistics.
• The Flow Statistics pages (Figure 4-20 and Figure 4-21). The Service Flow Summary
page provides upstream/downstream packet counts and upstream dropped packet
percentage for all defined service flows. Each Service Flow ID serves as a hyperlink
to a Service Flow Details page, which provides detailed flow statistics about the
particular service flow. A hyperlink at the bottom of the Service Flow Details page
leads back to the Service Flow Summary page.