User's Manual

C–1

070-20000750-01 Rev A

Appendix

Command Line Interface (CLI)

Each Base Station Unit and Subscriber Unit includes a simple command line interface

(CLI) accessible via Telnet

Accessing and Using the CLI

To access and use the Base Station Unit’s and Subscriber Unit’s command line interface:

1. Telnet to the unit’s IP address.

2. At the Login: prompt, enter ISP. (There is also a Debug logon level, which is re-

served for Aperto use. The Subscriber logon level applies to Subscriber Units only.)

NOTE: All CLI entries, including logon level and password, are case-sensitive.

3. At the Password: prompt, enter the correct password for the specified logon level.

The CLI uses the same passwords as the Web interface. The default password is

isp (case-sensitive). Passwords can be changed via the Web GUI.

4. When the CLI# prompt appears, you are in the CLI.

a. For a list of commands, type ? (the ? will not appear on the screen; pressing

[Enter] is not necessary). The CLI will respond with a list of the available com-

mands groups.

b. To display information about the use of a specific commands, including com-

mand parameters, enter the command and press space bar followed by ?.

5. If there is no activity on a connection for 30 minutes, the CLI will disconnect.

6. When you are finished with the CLI, disconnect from the RS-232 Craft Port, or end

the Telnet session by entering the killTelnet command or simply closing the Telnet

application.