User's Manual

1–1
10004880 Rev. D1
1
QuickStart Guide
This chapter outlines the basic procedure for installing PacketWave 200 Series Subscriber
Equipment and putting it into operation. It identifies the minimal requirements for getting
the equipment up and running, and assumes that configuration using DHCP and
WaveCenter™ Configuration Manager has been performed as described in the
PacketWave 1000 Base Station Unit
manual.
WARNING: Outdoor installation procedures should be performed by qualified pro-
fessionals following all safety and other requirements and acting in
accordance with standard practices and procedures. Failure to meet
safety requirements and/or non-standard practices and procedures
could result in personal injury and/or damage to equipment.
Step 1. Prepare for Installation
A. Before visiting the subscriber’s site:
i. Make sure that the necessary system configuration has taken place (as
described in the
PacketWave 1000 Base Station Unit manual).
ii. Verify that the Subscriber Unit configuration file has been created using Config-
uration Manager and either saved on the BSU’s TFTP server, or (for local config-
uration mode) saved on a disk and provide to the installer.
iii. Verify that the DHCP server has been configured with the Subscriber Equip-
ment’s IP and MAC addresses and its configuration file name. Make a note of
the IP address for use during installation.
iv. Verify that the DHCP and TFTP servers have the appropriate route to the
Subscriber Unit installed.
v. To perform PC-less installation using the auto-alignment feature, use the Aperto
Installation Manager (AIM) utility in Provision mode to pre-configure the Sub-
scriber Unit. For local configuration mode (see step ii above), click on Import CM
database and specify the configuration file location and name.