User's Manual

Chapter 5. The PacketWave AIM
5–16
10004880 Rev. D1
.
Figure 5-16 Installation Results Window
23. It is important to check the RF and IP transmission results to see if you have the
best possible wireless connection. If the results are not acceptable, perform the
steps described under Re-aligning the Antenna (Continue with Setup Mode) to
repeat the alignment process:
24. If you are ready to close the AIM, click on the Exit button of the Installation Results
window. The AIM will prompt for confirmation that you really want to exit.
NOTE: Advanced Installation Manager (AIM) performs radio checks following the
antenna alignment. This will allow the installer to check radio cables during align-
ment testing if no signal or a weak signal is being shown on the alignment
screen. This may cause confusion in detecting the difference between a radio not
properly connected and no coverage. Click on the finish button from the antenna
alignment screen, if in any doubt. The radio will be checked and the user will be
informed about the radio connectivity.
Viewing Status of the Wireless Link (Link Status Mode)
To view link status:
1. Go to the Install Option window (Figure 5-3) in one of two ways:
• Perform steps 1 through 5 under Using the Aperto Installation Manager on page
5-4.