User's Manual

5–17
10004880 Rev. D1
Chapter 5. The PacketWave AIM
• After completing an AIM mode, click on the Previous button until the Install
Option window is displayed.
2. Select Link Status and click on the Next>> button.
3. The Link Status window shown in Figure 5-17 will be displayed, showing local sig-
nal strength (as received by the SU) and remote signal strength (as received and
reported by the BSU) over time.
4. Click on the Next>> button when you are finished viewing the link status. The Install
Options window (Figure 5-3) will be displayed.
Figure 5-17 Link Status Window for PacketWave 200
NOTE: In scanning mode of AIM, the Subscriber Unit also adjusts the synchro-
nization. The synchronization is necessary to match that of the Base Station. It is
normally carried in the wireless frame. Since it is possible that the SU has not yet
found the appropriate signal as it is scanning, it is possible that the synchroni-
zation adjustment may be misaligned. To ensure proper antenna alignment, do
not spend more than 10 minutes in the alignment phase of AIM. Use the previous
and next buttons to restart the process at least every 10 minutes.