User's Manual

5–19
10004880 Rev. D1
Chapter 5. The PacketWave AIM
.
Figure 5-19 Test Results Window
Pre-provisioning a PW200 for Later Installation (Provision Mode)
The Provision mode is typically used to provision a PacketWave 200 in the lab prior to
installation. This enables the audio auto-alignment feature, described in Chapter 4.
NOTE: The Provision mode can also be used to re-enable the audio auto-align-
ment feature, should that be desired. After Provision mode, the PacketWave 200
is configured to go directly into audio alignment mode at power-up. If the audio
auto-alignment feature has not been enabled by using the AIM Provision mode,
alignment can be performed only using the AIM.
To use the Provision mode:
1. Go to the Install Option window (Figure 5-3) in one of two ways:
• Perform steps 1 through 5 under Using the Aperto Installation Manager on page
5-4.
• After completing an AIM mode, click on the Previous button until the Install
Option window is displayed.
2. Select Provision and click on the Next>> key. The Configuration Window will be dis-
played, as shown in Figure 5-5.
3. Configure the PacketWave 200 as described in steps 8 through 14 under Basic Con-
figuration on page 5-7.
4. After configuration has been completed, the AIM will reset the PacketWave 200,
enable audio auto-alignment, and display the Provisioning Results window similar
to that shown in Figure 5-19.