- Apex EmergeCard Remote Access User Guide

Emerge Card Remote Access User Guide Installation •
••
• 14
To connect to a user pod
1 Make sure the Emerge system is turned off and unplugged.
2 Place the Emerge system in the desired location. The maximum cable length between the Emerge
and the target system should be no longer than 12 feet.
3 Connect the mouse, video, and keyboard interconnecting cables to their respective jacks on the
back panel of the EmergeCard.
4 Connect the other end of the mouse, video, and keyboard interconnecting cables to their
respective jacks on the user pod.
5 Connect the local mouse and keyboard to the jacks marked with their respective symbols on back
panel of Emerge.
6 Plug in your remote access connection to the modem or network connection port.
7 Plug the power cord into its socket on the back panel of the Emerge system.