Specifications
1.800.338.7337 / www.soundoffsignal.com
66
66
Flashers
- Heavy Duty, Alt Alert, for LED Lights
LED Light Flashers
2 Output w/ 8 Flash Patterns #ETFFCØ2LED
6 Output w/ 8 Flash Patterns #ETFFCØ6LED
12 Output w/ 9 Flash Patterns #ETFFC12LED
• Synchronizes all LED warning lights - overrides all SoundOff Signal LED warning lights to take over pattern control
• 2 & 6 Output LED Flashers offer 8 user selectable fl ash patterns: Double, PowerPulse™, Quint, ETM™, Q-Switch™,
WarpFlash™, Inter-Cycle™ & Quad
• 12 Output LED Flasher offers 9 user selectable fl ash patterns: Double, PowerPulse™, Quad, ETM™, RoadRunner™,
Quint, Inter-Cycle™, Q-Switch™, WarpFlash™
• For use with LED lights only
6“ (15 cm) L x 3.4” (86 mm) W x 1” (25 mm) D
Mounts on 5.5” (14 cm) centers
12” (30 cm) wires
12 Output
3.2“ (81 mm) L x 0.8” (20 mm) W x 0.8” (20 mm) D
Mounts on 2.8” (71 mm) centers
12” (31 cm) wires
2 Output
5.5“ (14 cm) L x 3.3” (84 mm) W x 1” (25 mm) D
Mounts on 5” (13 cm) centers
6 Output
LED Flasher Flash Patterns
ETM™ ...................... Fast Simultaneous fl ash pattern @ 3.6 f.p.s.
Inter-Cycle™ ..........Cycles continuously through 2 - Quint™ patterns & 4 - WarpFlash™ patterns
PowerPulse™.........Alternating (wig wag) fl ash pattern @ 3.0 f.p.s.
Quad ........................ Four consecutive fl ashes @ 235 f.p.m.
Quint .......................Five consecutive fl ashes @ 140 f.p.m.
Q-Switch™ ............. Cycles through 3 fl ash patterns: Double Flash Alternating, Fast Simultaneous Pulse & Fast Alternating
@ 1.9 to 3.0 f.p.s. - pattern repeats every 5.4 seconds
WarpFlash™ ...........Alternating (wig wag) fl ash pattern @ 700 f.p.m.
LED Strobe Pulse Module
#ETLEDFC1 (for use with LED Lights only)
• Converts non self-contained LED warning lights into a
“Strobe Pulse” fl ash effect
• Flashes any 12 volt LED light up to 3 amps
• For use with LED lights only
• Solution for erratic fl ash patterns
• Adds 10 watt load across LED lamps restoring fl ash rate of
mechanical, turn signal & hazard fl ashers
• For use with LED lights only
LED Load Module
#ECVLDMDLØ1 (for use with LED lights only)
3“ (76 mm) W x 2.43” (62 mm) H x 0.75” (19 mm) D
Mounts on 2.4” (61 mm) centers
5.5” (14 cm) wires
3“ (76 mm) W x 1” (25 mm) H x 1.5” (38 mm) D
Mounts on 2.5” (64 mm) centers
16” (41 cm) wires